Occupational Safety & Health Administration
Hand And Power Tool Safety
Other Resources
|
Grizzly G8101 90° Aluminum Corner Clamp
|
Tools & Hardware > C-Clamps > Item 14
 |
Grizzly G8101 90° Aluminum Corner Clamp
|
by Grizzly
Sales Rank: 25767
|
$14.95
At Amazon
on 11-29-2008.
|
|
Product Description
Quick, one-handed operation and rugged cast aluminum construction make this 2 3/8" capacity 90 degrees miter clamp a sure winner. Dependable pivoting clamp head ensures that your corners provide plenty of access to your work to allow stapling or nailing. Cast mounting holes make bench attachment a breeze.
Owner Reviews, Ratings, Comments and Criticism
I have been looking to upgrade the four rather "lightweight" corner clamps that have served me reasonably well for quite a few years. I almost exclusively have used them to buld wooden picture frames, but have reached the point where I found that the small vise type rods used to tighten the clamps were becoming increasingly difficult for my old fingers to use. The Grizzly G8101 clamp appeared to be a potenially good choice, but I was a bit hesitant concerning the single "inside clamping" system and decided to only buy one to see how well it functioned before committing to purchase three more. As it turned out, that was a prudent choice. The clamp is indeed beefy and well built. However, I found that the lone clamp does create difficulty when attempting to get a tight fit between two pieces of a frame. The biggest issue is attempting to hold the two pieces together while tightening the clamp. Under these circumstances, one can immediately see the value of having a seperate clamp for each side of the two frame pieces being joined. Further, when using a two sided clamping system, after a dry test fit, it is extremely helpful to only have to loosen one side to add adhesive and then firmly press that piece back into position alligning it against the one that has remained fixed in the clamp. The "Grizzly" does not allow for this type of manuver and when trying to use it, I found myself wishing for a "third hand" to complete that task. Another problem that I noted was that the "inside corner" clamping system can tend to drive even a perfectly cut 45 degree joint a bit open on the interior part of the seam. I have however, decided not to return the clamp as the initial outlay was not great and it might serve some other less precise need I might encounter in the future. All in all though, I cannot recommend it for fine wood framing joints. From my personal experience, I would suggest that anyone requiring a clamp for the purposes described here would be better served with a two sided holding system with well sized gripping handles.
|
Grizzly G8101 90° Aluminum Corner Clamp
Available from Amazon
Price: $14.95
Updated on 11-29-2008.
|
|
|
